Zero88 Solution XL User Manual download pdf (Page 10)

Setting Up the Desk for Programming

1 Set ALL faders at zero, set Grand Master to

full.

2 Turn the Mode switch to Program. Program

light will come on.

3 Push the Master A fader to full.

4 Check memory Page is showing ‘1’.

Programming a Memory

1 Select the memory Page required using the

Page ‘+’ and ‘-’ controls.

2 Press the Flash/Preview button to select the

memory (1-12) that you wish to program. The

Preview lights will show any previously

programmed scene; the Preview light of the

memory selected will flash slowly and the

Page display will change from 1 (for example)

to P1, a reminder that the page selected is

being previewed.

3 Set up a scene on Preset A.

4 Briefly press the Program button to transfer

the Preset A levels to memory. The new

memory is immediately displayed on the

yellow Preview leds to verify that this

information has been recorded.

5 Repeat steps 1 to 4 to program additional

memories.

Clearing a Memory

1 Select a memory to be programmed or

program a new memory as described above.

2 Set Master A down to zero.

3 Briefly press Program to clear the memory by

storing a scene with all levels at 0. Any

preview lights that were on go off.

Blind Programming

This is possible using the Level Match feature

described on Page 11.

/p9/3

HINTS

Programming Appears Not To Work

Check that the Grand Master and Master A are up to full,

since with Master A at zero, a blank memory will be

programmed. Simply fade up the Grand Master or Master A

and reprogram the memory.

The scene recorded is not the scene that was

wanted.

Check that none of the Memory Masters or the Effects Master

were up whilst you were programming. If any of these masters

were on, this will be shown on the Output Lights and the

memory that will be recorded will be the mixture of levels

set by Preset A and levels set by the Memory Masters that

were up. This is an essential feature of the desk.

Reprogramming a Memory

If the memory chosen is not empty (shown by the preview

lights coming on), pressing the Program button will overwrite

any previous information with the current settings of Preset A;

the old memory will be lost.

Changing the Memory Selected

To change the memory that you have selected within a Page,

simply press another memory Flash/Preview button. To

remove the memory preview information from the Preview

lights in Run, press the Flash/Preview button of the memory

once again.

‘PC’ in the Page Display

When ‘PC’ is shown (Preview Ch), this means that ‘Ch’ was

showing in the Page display when the memory was selected.

Pressing the Flash button again will return the display to ‘1’ or

using the Page +/- buttons will move to the correct Page

required.

Programming the Memory

7359500/p9/3 Page 9

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

Comments to this Manuals

No comments

Zero88 Solution XL User Manual Page 10

Comments to this Manuals

Related products and manuals for Recording Equipment Zero88 Solution XL