Zero88 Solution XL User Manual download pdf (Page 26)

Error Messages

Memory Problems

The memory Page displays may show one of the

following messages if a memory error is detected

when the desk is turned on.

Mode switch in any position.

Super User set up options have been

corrupted

The output Strobe / Full Level channel

memory has been corrupted

The DMX patch memory has been

corrupted

Lost Pattern - The sequence memories

have been corrupted

The MIDI lighting control data has been

corrupted

All these problems are likely to be transitory.

They may require a Super User Clear Memory

and/or Reset operation and some

reprogramming. Always keep a copy of important

shows on a Memory Card.

Mode switch in MIDI Setup In / Slave

— Display —

Page Step No.

Active Sensing loss of MIDI data -

check if the cable is unplugged

or open circuit

Illegal System Exclusive

command received

/p25/4

Hardware Problems

The Lightmaster XL will display ‘CR’ (crash) in

the Page display if the hardware is not operating

correctly. There are two types of crashes: those

that will allow some desk operations to proceed

despite the fault and those that prevent the desk

working completely.

Faults that allow desk operations to continue:

— Display —

Page Step No.

Chaser frame memory recovery

failed (Faulty Eprom )

Analogue input ICs not reading

0 volt line correctly

Analogue input ICs not reading

‘Vref’ correctly

Faults that prevent the desk working completely:

DMX transmission has failed

DMX transmitted data not being

transmitted correctly

DMX transmitted data not being

transmitted correctly

Eprom checksum not correct

(Faulty Eprom)

RAM testing has failed

(Faulty RAM)

Mode switch in faulty position

Hardware Problems (Continued)

When a hardware problem is detected the desk

will stop but the outputs will stay at their previous

levels.

To continue after a hardware problem is

detected, press the Page +, Page - or Go buttons.

If the problem persists the desk will again be

halted until the hardware is repaired.

Memory Card Errors

Insert Card

Battery Low

Not Formatted

Not a Lightmaster XL Card

No Data Saved

Corrupt Card

Protected

Not Verified

Card Error

Card Error

Card Send Error

Card Receive Error

Card Addressing Error

Error Messages

7359500/p25/4 Page 25

1 2 ... 21 22 23 24 25 26 27 28 29 30

Comments to this Manuals

No comments