Zero88 FROG 2 Instruction Manual download pdf (Page 108)

Cues, Stacks and Pages

Page 108 Frog 2 Operating Manual – Issue 4.3

Naming Cues

Select the cue in the Cue Stack Window and press the SET key. Type in the required

name using the external keyboard and then press ENTER to complete.

Enter the command CUE S/C SET or SET CUE S/C ENTER. The Edit Cue Name popup is

displayed on the touch screen (see below). Type in the required name using the external

or on-screen keyboard and then press the [OK] button to complete.

It is also possible to name a cue at the same time as it is being recorded by entering the

following command: RECORD S/C SET

The Edit Cue Name popup is displayed on the touch screen (see above). Type in the

required name using the external keyboard and then press the [OK] button to complete.

Editing Cue Output Levels

In order to edit a cue you first need to load it into the Program Window, by entering the

following command:

LOAD S/C ENTER (S = Stack Number, C = Cue Number)

This loads the cue into the programmer and outputs the programmed DMX values. You

can then select fixtures and make changes to the parameter output levels as necessary, in

the same way as when recording the cue initially (see earlier).

To record the changes to the same cue press the UPDATE key.

The Update Options Window is displayed – see Programming chapter for further details.

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 183 184

No comments

Zero88 FROG 2 Instruction Manual Page 108