Zero88 FROG 2 Instruction Manual download pdf (Page 95)

Programming

Frog 2 Operating Manual – Issue 4.3 Page 95

Wheel Editing Modes

The desk provides a number of wheel editing modes which are user selectable and apply

when editing several fixtures at the same time. For each attribute there is an unshifted

and a shifted wheel mode.

The unshifted wheel mode is applied when the control wheel is moved. The shifted wheel

mode is applied when the SHIFT key is held down and the wheel is moved.

The shifted wheel mode for the currently selected attribute is displayed on the touch

screen. To change the editing mode, press the soft key on the touch screen, and then

select the required edit mode from the options displayed in the popup menu.

The different wheel editing modes are described below:

Absolute Mode

When several fixtures are selected and a fixture parameter is adjusted using a control

wheel, the adjusted parameter for all the selected fixtures goes to the same absolute

value. For example – Select fixtures 1 – 5 and adjust a parameter:

Fixture Parameter Fixture 1 Fixture 2 Fixture 3 Fixture 4 Fixture 5

Original Value 30 20 40 10 50

New Value 15 15 15 15 15

Change in Value -15 -5 -25 +5 -35

Relative Mode

When several fixtures are selected and a fixture parameter is adjusted using a control

wheel, that parameter on each of the selected fixtures will increase or decrease by the

same amount from its original value. This mode is most often used for adjusting position

parameters (pan and tilt) For example:

Fixture Parameter Fixture 1 Fixture 2 Fixture 3 Fixture 4 Fixture 5

Original Value 10 20 30 40 50

New Value 15 25 35 45 55

Change in Value +5 +5 +5 +5 +5

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 183 184

No comments

Zero88 FROG 2 Instruction Manual Page 95