Zero88 FROG 2 Instruction Manual download pdf (Page 111)

Cues, Stacks and Pages

Frog 2 Operating Manual – Issue 4.3 Page 111

Playing Back Cues

Before playing back the programmed cues in a cue stack, it is important to clear the

Program Window by pressing the CLEAR button. This clears out any unrecorded

commands and sends the fixtures to their default values, with the exception of the intensity

parameters, which are kept at 0%.

Selecting the Cue Stack

Select the required page of playbacks using the PAGE+ and PAGE- buttons, then press

the Stack SELECT button above the cue stack you wish to play back. The LED in the

SELECT button is lit to indicate that it is the active cue stack.

Selecting Cues

Use the cursor keys to select a cue or enter one of the following commands:

CUE N ENTER selects cue N as the next cue on all stacks that are selected and running.

CUE S/C ENTER selects cue C on stack S provided that stack S is running.

Outputting Cues

To play back the cues in a cue stack in sequence:

Raise the stack master fader to full. Press the GO button for the selected playback.

To output the next cue in the cue stack, simply press the GO button again.

To output a specific cue in the cue stack, use the cursor keys to select the next cue in the

Cue Stack Window (indicated with the yellow highlight bar), then press the GO button or

enter the following command: S/C ENTER.

Other commands to trigger a specific cue are as follows:

CUE N GO triggers cue N on the stack associated with the local GO button pressed.

CUE N MASTER GO triggers cue N on all selected and virtual stacks.

To snap to the next cue in the cue stack (ie ignore all timing information in the cue) hold

down the SHIFT key and press the GO button.

The red LED in the GO button is on when the stack is outputting and flashes when the

outputs are fading between cues.

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 183 184

No comments

Zero88 FROG 2 Instruction Manual Page 111