Zero88 FROG 2 Instruction Manual download pdf (Page 142)

Palettes

Page 142 Leap Frog 48/96 Operating Manual – Issue 3

Recording a Palette

Set up the required fixture data in the programmer.

Press the COLOUR, BEAMSHAPE or POSITION key to make the MFKs palette selection

keys.

Use the PAGE UP or PAGE DOWN keys to select the required page.

Press and hold down the corresponding palette MFK for two seconds. The LED in the

palette MFK is lit when the palette has been recorded.

Note – Recording Palettes

Only the tagged fixture parameters of the selected attribute (eg Colour) are recorded into

the palette.

Editing a Palette

Editing a palette is carried out by first loading the palette into the Programmer, adjusting

the dimmer and fixture parameter values as required, and finally updating to save the

edited palette back to it’s original location.

Display the appropriate palette window on the monitor. Select the palette to be edited, then

press the LOAD key. The Load Options Window is displayed on the monitor:

Select the [OK] button to load the palette into the Programmer.

Adjust the levels of the dimmer channels as required using the preset faders.

Adjust the levels of the fixture parameters as required using the control wheels.

Press the UPDATE key. The Update Options Window is displayed on the monitor.

Set the update options as required and then select the [OK] button to complete the edit.

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 173 174

No comments

Zero88 FROG 2 Instruction Manual Page 142