Effects
Leap Frog 48/96 Operating Manual – Issue 3 Page 147
Effect Parameters on the Wheels
When the effect wheel groups are active (ie the EFFECTS LED is lit), the wheels control
the speed, size, offset and rotation parameters. The Effects parameters are assigned to
the control wheels as follows:
Thumb Wheel First Finger Wheel Second Finger Wheel
Wheel Group 1
Speed Size Offset
Wheel Group 2
Speed Size Rotation
If you apply different effects to different parameters of the fixtures (eg Rainbow and Circle)
you can use the Speed wheel to control the speed of all the effects in one go.
At any time you can reload a memory into the Program Window and modify the speed of
all the effects in that memory by selecting the effects wheel group and moving the Speed
wheel.
Recording an Effect
Select a fixture or fixtures. Apply one of the standard effects, then adjust the effect
parameters as required using the control wheels.
Press the EFFECTS key to make the MFKs effect selection keys.
Use the PAGE UP or PAGE DOWN keys to select the required page.
Press and hold down the corresponding effect MFK for two seconds. The LED in the effect
MFK is lit when the effect has been recorded.
Comments to this Manuals