Zero88 FROG 2 Instruction Manual download pdf (Page 144)

Palettes

Page 144 Leap Frog 48/96 Operating Manual – Issue 3

Outputting a Palette

Select the required fixture(s).

Press the COLOUR, BEAMSHAPE or POSITION key to make the MFKs Palette Selection

Keys. Use the PAGE UP or PAGE DOWN key to select the required page.

Press the Palette MFK to output the data recorded in that palette for the selected fixture(s).

Note – Outputting Palettes

When outputting a palette, if a selected fixture is not programmed in the palette, but there

are one or more fixtures of the same fixture type that are programmed in the palette, then

the fixture outputs the value that is programmed for the first fixture of that type.

Example – Fixture 1 (MAC 250) only is programmed in colour palette 5; no other fixtures

have programmed values in this palette. Fixture 7 (another MAC 250) references colour

palette 5. It sees that there is no value programmed for fixture 7 in this palette, but fixture 1

is the same fixture type and has a value, so it uses the value stored for fixture 1.

Note – Outputting a Palette over Time

Holding down the TIME key and pressing a palette MFK will crossfade to the palette output

values in the internal Fade Time. The internal Fade Time can be found and adjusted on

Special Page 1 of the MFKs.

Deleting a Palette

Display the appropriate palette window on the monitor. Select a programmed palette to be

deleted. Press the DELETE key. The Delete Window is displayed on the monitor:

Select the [OK] button. A confirmation window is displayed. You can then confirm the

deletion or cancel the operation.

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 173 174

No comments

Zero88 FROG 2 Instruction Manual Page 144