Macros
Leap Frog 48/96 Operating Manual – Issue 3 Page 153
Copying a Macro
Display the Macro window on the monitor. Select a programmed macro to be copied.
Press the COPY key. The Copy Window is displayed on the monitor:
Enter the destination (To) macro number and then select the [OK] button to confirm the
operation.
If the destination macro is unprogrammed – the source macro is copied to the destination
macro.
If the destination macro is programmed – a warning message is displayed. You then have
the option to overwrite the macro or cancel the copy operation.
Running a Macro
A macro can be run using any of the following methods:
• Click on the macro in the Macro Window on the monitor.
• Use the cursor keys to select the macro in the Macro Window and then press the
ENTER key.
• Press the MACRO key to make the MFKs macro selection keys. Use the PAGE UP or
PAGE DOWN keys to select the required page. Press the macro MFK.
• Triggering a memory with an associated macro.
• Raising a submaster with an associated macro.
Note – Running Fixture Macros
To run one of the automatic fixture macros (Reset, Lamp On or Lamp Off) select the
fixture(s) first before running the macro as described above.
Comments to this Manuals